KanexPro HDSC12D Manual - 2. Front Panel
HDSC12D
6
2. Front Panel
Front Panel description.
1. Power indicating LED. It will keep on red when the unit is connected with power.
2.
IR sensor. It is for IR remote controlling, receiving the signal of IR remote.
3. Signal indicating LED.
4. Video source selection buttons. You can select video/audio sources by these buttons. And
Video source including three different signal: YPbPr, C-Video and S-Video.
5. Signal channel selection buttons.
6. Resolution selection buttons. These including
1024×768, 1280x720p, 1280×800, 1360×768,
1920×1080p.
7. MIC volume control buttons. “MUTE” for mute MIC volume, “
△
”for MIC volume up, “
▽
”for
MIC volume down, loop controlling.
8. Line volume control buttons. “MUTE” for mute line volume, “
△
”for line volume up, “
▽
”for line
volume down, loop controlling.
3. Real Panel
Rear Panel description
① Two RCA connectors for stereo audio output, one VGA output, one HDMI output with audio
embedded, one TP port for HDMI extending
② Four VGA connectors for VGA inputs.
③ Four HDMI connectors for HDMI inputs.
④ Four 3.5mm audio connectors for VGA audio inputs.
⑤ One Component video input: Y/Pb/Pr, two composite video inputs: C-Video, one Separate
video input: S-Video, two pairs L/R for analog audio input.
⑥ One RS232 port for series control, one USB port for firmware update.
⑦ Two MIC connectors: MIC with pre-amplification, LINE for audio direct input. One TCP/IP port
for network controlling.
⑧ Amplifier with 2x10W@8Ω output.