KanexPro SP-HDCAT1X8 User manual - page 5
SP-HDCAT1X8
4 |
P a g e
Connection Instruction:
1). Connect HDMI input with HDMI output of source device.
2). Connect IR blaster extension cable to the IR extender out port.
3). Connect RJ45 port with RJ45 input port of HDMI extender RX.
4). Connect HDMI output of HDMI extender RX to HDMI input of HDTV and set the TV source input to correct HDMI input channel.
5). Power on the device (power indicator led lights) and it works.
FAQ’s:
Q: TV display showing the message on screen: “waiting for connection...” on the bottom right corner?
A: Please check if the power supply of TX (sender) and RX (receivers) are well connected and the power indicator led
lights are on and make sure all cables are firmly connected.
Q: TV displays the message on screen: “Please check the TX input signal”?
• 1) Please verify if there is an HDMI signal input of TX connected to a device and its powered on.
• 2) Try to connect the signal source directly to display to see if there is signal output from source device or
change the signal source, HDMI cables and try again.
Q: Display not smooth and stable
• 1) Please check the cable length between TX(sender) and RX(receiver) is within the required range. (less
than 25ft of HDMI cable is recommended or shorter).
• 2) Click the “reset” button on the TX/RX panel, reset and then reconnect.