KanexPro SW-HD4X24K User Manual - page 4
3
SW-HD4X24K Matrix Switcher
Rear Panel
1. Input Source: These slots are where you connect the HDMI source output from DVD, PS3.
2. HDMI OUT: This slot is where you connect the HDTV or monitor with HDMI cable.
3. Stereo OUT: This slot is where you connect to the speaker with 3.5mm earphone cable.
4. Toslink OUT: This slot is where you connect to the amplifier with optical fiber cable.
5. DC IN: Plug the 5V DC power supply into the unit and connect the adapter to AC wall outlet.
Notice:
The Toslink and Stereo audio follow the OUT A HDMI audio.
The In1 (The first input port) support HDCP2.2 input only.
The In6 (The sixth input port) support MHL input only, uses MHL to HDMI Cable to connect smart phone and matrix.
The sure, output A supports ARC function only.
VI. Remote control
STANDBY: Press this button will standby or power on the matrix.
Audio EDID: Press this button will select the audio output mode (2.0CH, 5.1CH, 7.1CH), and the LED will indicate the corresponding state.
ARC: Press this button will open or close the ARC function, and the LED will indicate the corresponding state.
PIP: Press this button will open or close the PIP function. When open PIP function, the OUTA and OUTB will switch to the same input source.
Select: Press this button will select the PIP source.
Enter: Press this button will confirm the select PIP source.
OUTA: Press these buttons will fast switch to select input source to HDMI OUTA. And the LED will indicate the corresponding input source.
OUTB: Press these buttons will fast switch to select input source to HDMI OUTB. And the LED will indicate the corresponding input source.