KanexPro SW-SDI8X8 User Manual - page 5
SW-SDI8X8
4
5 CONNECTIONS AND OPERATION
5.1 Connections and Operation
(1) Connect the product to appropriate power;
(2) Connect SDI signal sources to the SDI inputs “1” … “8” through high-quality
75Ω coaxial cable(RG59、RG6 cable or equivalent as well);
(3) Connect the SDI monitors or other SDI devices to the SDI outputs “A” … “H”
through 75Ω coaxial cable;
(4) Operate the SDI signal source to start the show;
5.2 FUNCTIONAL OPERATION
To select the input source, or the Power On / Power Off, here are three operation
ways:
1. Remote-Control Unit
1) To select the specified Input sources: press the serial number of the output
channel + press the serial number of the Input channel that you want, for
example: you want to choose Input 8 to be the output of the A channel, that is:
A 8
2) To select the next input source: press the button “△”corresponding to the
output.
3) To close the output: when the channel is open, press the yellow button
corresponding to the output channel.
4) To open the output: when the channel is closed, press the yellow button
corresponding to the output channel.
2. The button, the Power Switch and input selection indicator on the front
panel