KanexPro SW-SDI8X8 User Manual - page 6
SW-SDI8X8
5
The button ▼ ▲ on the front panel are used to select the input source, the Power
switch on the right side is used to shutdown or start up.
Digital tube on the front panel indicates which input the current output signal is
derived from.
3. Connect the PC’s RS232 interface to the RS232 on the back of the main
unit, user can select the input source, Power on and Power off by
entering the command through the "super terminal" on the PC.
The following is the RS232 control instruction sheet:
Shared control instruction
QS
Select the connection relationship between the source and sink
PON Turn on the main power supply
POFF Turn off the main power supply
Select the input source: serial number of the output channel + serial number of the
input channel + Enter
A1
A Channel selects Input1
…
…
A8
A Channel selects Input8
…
…
H1
H Channel selects Input1
…
H8
H Channel selects Input8
Close the output: OFF + serial number of the output channel + Enter
OFFA Cut off the signal which was sent to output A, make output A not displayed
…
…
OFFH Cut the signal which was sent to output H, make output H not displayed
Open the output: ON + serial number of the output channel + Enter
ONA Open the signal which was sent to output A, let output A display
…
…
ONH Open the signal which was sent to output H, let output H display
Note: inputting need not case sensitive.