KANGKE INDUSTRIAL LASER 2000 Assembly Manual - page 5
Install the upper flying wires; try to keep the
tension on all the wires equal. The wires
should be adjusted tight enough so there is no
endplay, but not so tight as to cause distortion
of either the fin or the stabilizer.
Install the main landing gear with the supplied
screws and washers. When installed correctly
the gear will have a slight sweep forward.
Install the tail wheel bracket. Align the tail
wheel pivot hole with the back edge of the
rudderpost.
The airframe can now stand on its gear
allowing clearance for the cowl. Temporarily
install the canopy deck. Line up the cowl and
open any holes that are necessary for engine /
exhaust clearance. Locate the holes for the
cowl mount. Remove the cowl and deck.
Assemble the gas tank. Be sure the flop tube
does not contact the rear of the tank. Bend the
vent line to the top of the tank and install the
fill tube if third line refueling is to be used.