KANGKE INDUSTRIAL TIGER SHARK-40 Assembly Manual - Congratulations!
Congratulations!
Kangke Industrial USA, Inc. brings you one of the finest Tiger Shark models available. Skilled
craftsmen combined with top grade materials and precision jigs have all come together to produce an
aircraft with outstanding flight qualities. If you follow the directions carefully the performance of this
aircraft will surely please you.
Specifications:
Length
54.5 in.
Wing Span
47.5 in.
Area
535 sq. in.
Weight
5.5-6.5 lbs.
Engine
40-52 2 Cycle
Kit Contents:
Fuselage 1
Wing panel
1
Ailerons 2
Canopy 1
PACK 1
Stabilizer 1
Elevator 1
Fin
1
Rudder
1
PACK 2
Servo tray
1
Servo block
2
Servo rails
2
PACK 3
Fuel tank
1
Wheels 3
Main gear
2
Nose Gear
1
Control horn
1
Control wire
6
Control rod
1
Bellcrank 1
Hardware pack
1
Clevises 5
Pack 4
Manual 1
Decal kit
1
The following additional
items will also be needed to
build the Tiger Shark
HOBBY ITEMS:
4 oz. 30 min. epoxy
Popsicle sticks
Hobby knife
Med. CA 1 oz.
Radio 4-channel min.
4 servos
Fuel line 20-inches
Motor (Tiger Shark .40/52)
Muffler
Spinner (Super Kraft 2.25”)
18-inch servo extension
Canopy glue
HOUSEHOLD ITEMS:
Paper towels
Alcohol
Masking tape
Ruler
Felt tip pen
Screwdrivers
Pliers
RTV silicone
Sewing thread
5/32 drill
1/4 drill
1/8 drill
1/16 drill
Clothes pins
Read each step of the instructions carefully. Be sure you understand what is required and what the procedure
is before you glue or cut anything. How well you assemble this model will have a direct effect on its flight
characteristics.
This manual is the sole property of Kangke Industrial USA, Inc. Reproducing any part without the consent of
Kangke Industrial USA, Inc. is a lawful violation.
Warranty:
Kangke Industrial USA Inc. guarantees the kit to be free of defects in both material and workmanship at the date of purchase. This
warranty does not cover any parts damaged by use or modifications. In no case shall Kangke Industrial’s liability exceed the purchase cost of this
kit. Since Kangke Industrial has no control of final assembly and material used by user for final assembly, no liability shall be assumed or
accepted for any damage resulting from the use by user of final user-assembled products. This kit has been flight test for normal use. If the plane
will be used for extremely high stress flying, the modeler is responsible for reinforcing the high stress points. Inspect this kit immediately after
receiving it, report any missing and damaged parts within 10 business days otherwise the claim may be denied.
2