845s gb date code 0001l2001 9800 0332 01 a.
Service and repair manual model 845s 2 warranty and liability statement all repairs may be completed with standard workshop tools and equipment. Service tools use only authorized parts. Any damage or malfunction caused by the use of unauthorized parts is not covered by warranty or product liability....
3 service and repair manual model 845s fig. Part no. Description of part no. Req. 41 9170 3252 10 brush spring (2) 42 9170 4652 10 speed control switch (1) 47 9170 3254 10 upper handle mount (1) 50 9170 4652 30 motor cover (1) 51 9170 4656 80 left handle half (1) 52 9170 4657 60 right handle half (1...
Service and repair manual model 845s 4 assemble thrust washers #107 and belleville spring washers #78 into intermediate housing #46 as illustrated. Note: use oil on all areas to be press fit %see page 5 for additional lubrication and service notes ____________________________________________________...
5 service and repair manual model 845s l l l l l l l l l l l lubrication notes: (type "s2" grease, no. 9170 4664 70) fill piston #95 with grease and assemble to connecting rod #100 with wrist pin #94. Front surface of piston to be free of grease. Lubricate o-ring #67 with grease. Place 1.5 oz. Greas...
Service and repair manual model 845s 6 fig. %notes 54, 55, 56 to remove belly shroud #56 from tool, insert small screw driver into groove between belly and side shrouds #54 and #55, about 1/3 of the way from the motor end, as shown. Pry out and down on both sides of the tool. 54, 55 to install the s...
7 service and repair manual model 845s wire color wiring schematic inductor boat wire origin or no. 110 v 120 v 230 v part no. Connection 1 blue white blue cord switch 2 brown black brown cord switch 3 red red red field lead 9 4 red red red field switch 5 yellow yellow yellow field brush holder 6 bl...
Service and repair manual model 845s 8 electrical testing electrical test before assemby all electrical parts must be checked for safety, and that they conform to specification. Testing the armature (flash testing) a armature shaft to lamination pack 1500 volts (min) b lamination pack to commutator ...
9 service and repair manual model 845s warning lethal voltages present!! Important on completion of the assembly, the unit must be flash tested at 4000 volts. Flash test 1. With the breaker completely assembled and with the switch "on", apply 2000 volts initially and increase rapidly to 4000 volts b...
Atlas copco berema ab, sickla industriväg 1a, s-105 23 nacka sweden telephone: +46 (0) 8 743 9600 fax: +46 (0) 8 743 9650 9800 0332 01 a 54-24-0975 drwg. 3 04/02.
