Kanguru 2.5'' User Manual - page 7
2. Double-click My Computer and then Double-click on your Disc Drive to
explore the drivers CD.
3. Open the KanguruEco Drive 2.5” or KanguruEco Drive 3.5” folder
depending on your model.
4. Open the Win98 Drivers folder in either the and run the file USB
Disk Win98 Driver Version 1.51.20.exe.
5. An installation wizard will guide you through the installation
process.
6. After the installation wizard has finished, simply plug in the drive and
Win98SE will finish loading the drive. You will then find a new drive letter
available under “My Computer”.
Note: You can Click Start→ Settings→ Control Panel→ Add/Remove Programs,
select USB Disk Win98 Driver and click Add/Remove Programs. Or you can click
Start→ Programs→ USB Disk Win98 Driver→ Uninstall.
Windows 2000/XP/Vista, Mac OS 9.x/10.x
The KanguruEco Drive does not require any driver files for Windows 2000, XP,
Vista, or Mac OS 9.x or 10.x. These operating systems include a generic USB
Mass Storage driver, which will support the KanguruEco Drive.
Simply plug in the KanguruEco Drive into a USB port and your OS will
automatically detect the new hardware and install the appropriate driver.
When the installation has completed successfully, you should find a new drive
letter has mounted in “My Computer” (Windows) or on your Desktop/Disk Utility
application (Mac OS) as Kanguru . You can now write and/or read files from your
KanguruEco Drive.
NOTE: If your KanguruEco Drive does not mount a new drive letter in My
Computer, you may need to partition/format the drive in Disk Management
(Windows).
Usage
The KanguruEco Drive power saving functions work without any setup or
configuration right out of the box. Just connect the drive to the PC and the
embedded power management processor will begin to operate and report the
drive status with LEDs right away. The four operation modes are listed below
with default configuration times:
Active mode initiates when there is reading or writing directly to/from the device.