Kanguru DVD Duplicator User Manual - page 10
2. A CD-R/RW writer of lowest #ID with a readable disc inserted.
*The default status is: “A”
•
DISC COUNTER
Set necessary quantity of blank CD-R/RW when you use AUTO EXECUTION.
1. “M” indicates manual operation – press the RUN button to start each function,
2. “A” indicates the KanguruDVD-Duplicator will start to copy when all of the drives are loaded
with blank media.
3. “1~8” indicates KanguruDVD-Duplicator will start to copy when the # (1~8) of blank DVDs or
CDs have been inserted and detected. For example: If you set this setting to 3, once you have
placed 3 blank CD in the drives, the duplication process will automatically start.
*The default status is: “M
”
•
SKIP READ ERROR
If you enable this function, the controller will skip the bad sectors on the source disc and finish
reading the disc. Below are the settings:
1. “NO” when a bad sector is detected in the disc, then the reader will display fail and the
duplication process will also fail.
2. “SHORT” when a bad sector is detected in the disc, then the reader will skip several KB of the
bad sector and continue reading.
3. “LONG” when a bad sector is detected in the disc, then the reader will skip several MB of the
bad sector and continue reading.
4. “SKIPPA” when bad sector is detected in the disc, then the reader will assume that the source
disc already finished and the duplication process will close the disc.
•
CD WRITING METHOD
Your KanguruDVD-Duplicator provides 3 different types of reading and writing modes for CDs:
1. “DAO” Disc at Once, most Frequent writing.
2. “TAO” Track at Once, the duplication process uses track by track to copy the disc.
3. “RAW” Raw writing method, when the “DAO” and “TAO” can not succeed in backing up your
disc, you may try this writing method.
*Default Setting is “DAO”
• DVD WRITING METHOD
Your KanguruDVD-Duplicator provides 2 different types of reading and writing modes for DVDs:
1. “DAO” Disc at Once, most Frequent writing.
2. “INC” Can be used to improve the compatibility of the final discs.
*Default Setting is “DAO”
• CD READING SPEED
Set the reading speed of the source drive.
Usable speed can be: “MX”, “01”, “02”, “03”, “04”, “06”, “08”, “10”,
“12”, “16”, “20”, “24”, “32”, “40” “46”, “48”, and “52”.
“MX” indicates the maximum speed. If you set this value to a value higher than the maximum
speed of your writer, your writer will operate at its maximum speed.
“MD” the reader uses the source disc media speed (default speed of disc), to read the source
disc.
The default value is: “MX”.