Kantech P345KPMTR Installation Manual - Installation Notes
DN1870-0905
10
Installation Notes
Unless otherwise specified in this manual, please follow these guidelines:
Important: Use only shielded cabling for connections.
1
Connect the reader to the controller. See
Figure 3
for connecting the reader to
a Kantech controller.
Note:
You can use a local power supply for the reader. If so, don’t connect the power
supply from the controller to the reader. The ground line of the local power
supply must be connected to the power supply of the controller.
Figure 3: Wiring Examples to Kantech Controllers
2
The unit needs to be operated with a power source with limited power
consumption according to EN 60950-1 (2003) paragraph 2.5.
3
Use of a pull-up resistor may be required by some controllers others than
Kantech controllers. Consult your controller manual.
4
For tamper wiring, connect Pins 11 and 12 to a
normally closed supervised input.