Kanto YARO2 User Manual - Setting Up Your Speakers
4
Supporting your digital lifestyle
™
Setting Up Your Speakers
The YARO2 Amp is designed to power a pair of passive speakers. We recommend the Kanto
YARO2 Passive Speakers.
1) Ensure that the YARO2 Amp is not plugged into power.
2) Connect the speakers to the amp as shown below using the supplied speaker cable.
Connect the RED (+) and BLACK (−) terminals from the passive speaker to the corresponding
terminals on the Amp, taking care not to reverse the wires. Simply unscrew the binding post
until you see the hole and insert the bare wire, then tighten the binding post finger-tight. If you
wish to place your speakers farther apart than the supplied cable will reach, we recommend
that you purchase a heavier gauge of speaker cable to minimize signal loss.
3) Connect the power cord from YARO2 Amp to the wall outlet.
ATTENTION
When the volume is high, this system can produce noise levels that could permanently damage your hearing.
Do not connect the Amp inputs to the speaker outputs of a stereo amplifier. Damage may occur. Use only the power
cord provided with the speakers.
AUX
OPT
USB
SUB
L
R
-
+
+
-
INPUT
+
-
INPUT
LEFT
SPEAKER
RIGHT
SPEAKER