Kanto YARO2 User Manual - page 9

9

Supporting your digital lifestyle

™

Auto Power-up / Auto Power-down

The YARO2 Amp is designed to save power when not in use. When no audio signal has been 

detected for 15 minutes, the YARO2 Amp will put itself into stand-by mode. If the audio signal 

returns via the same input that the YARO2 Amp was playing when it entered standby, the 

YARO2 Amp will wake up and resume playing. It can also be woken up manually by:

• Pressing the Standby Button on the Remote

• Pressing the Control knob on the Amp

If you do not find the Auto Power-up (APU) feature useful, you can disable it by pressing the 

Balance Reset button on the remote and holding it for 5 seconds. The Status LED will blink 

once to indicate that you have disabled the APU feature. To enable the APU if you have 

disabled it, simply press and hold the Balance Reset button again for 5 seconds. The Status 

LED will blink twice to indicate that you have enabled the APU.

Note that APU is always turned on when power is applied, but will only work after automatic 

power down. APU will not work if unit is manually switched to standby using the remote or 

control knob.