Kaption Audio 570-azr400x4 Owner's Manual - Wire Connections
- 7 -
Multi Channel Amplifiers
16. LPF (Low Pass Filter) Sub-woofer Control (570-AZR700X5 only)
The LPF controls the low pass crossover to select the desired frequency.
The frequency can be adjusted from 40Hz to 220Hz.
17. Wired Bass Remote Jack (570-AZR700X5 only)
Provides a wired remote control to the drivers seated location.
The Bass Remote controls the amplifier’s volume adjustment.
Wire Connections
B
EfOrE
CONNECTEd
ANy
pArTs
Of
ThE
spEAKErs
,
ENsUrE
ThE
spEAKErs
ArE
NOT
ENErgIzEd
ANd
ThAT
ANy
INpUT
sOUrCE
Is
sWITChEd
Off
.
1. Input - (Item 6 & 7) Be sure to lay the signal wire away from all power cables and
vehicle computers. Use high quality twisted pair interconnect cables to decrease
the possibility of radiated noise entering the system.
The amplifiers can use either a low level line-in or high level (Speaker Level
connection) signal from the source unit.
If the source unit is not equipped with RCA outputs, The amplifier can be connect
to the source unit to the high level (speaker connection) by following the high
level setup below.
• LOW LEVEL: Using RCA Connections (Low level input): If the source unit has
RCA outputs, simply attach a signal cable from the source unit to the amplifier’s
RCA input. Set the AS selector switch on the (item 8) to the “LOW” position.
• HIGH LEVEL: The amplifier features current sensing technology with the A
channel input. The REM (Item 4) wire connection is not required with the AS
selector (Item 8) set in the high position.
Use the high level output from the source unit and the HIGH LEVEL-IN ADAPTER
supplied with the amplifier. Splice the source unit speaker wires to HIGH LEVEL-IN
High Level In adapter wire setup
High Level In adapter