Kapture KPT-500 User Manual - page 10
10
e. Using the UP and DOWN button, highlight the required
sensitivity of the G-Sensor (2G is the most sensitive
setting only requiring small bumps to log footage as
Locked, and 8G is the least sensitive requiring a larger
amount of activity to log footage as Locked).
f. To confirm selection push the OK button, the KPT-500
will take you back to the VIDEO menu.
11. Set Park Mode
Park Mode will monitor for activity using the G-Sensor after
the car is parked, even if your ignition is turned off. If activity is
detected, the KPT-500 will record 60 seconds of footage.
To set park mode on your KPT-500 follow the directions below:
a. Ensure you are not currently recording. If the red record
indicator is flashing at the top left of the KPT-500’s
screen, push the OK button to stop recording.
b. Push the Menu Button twice, taking you to the SETUP
menu.
c. Using the DOWN button highlight the setting named Park
Mode and push OK.
d. Using the UP and DOWN button, highlight the required
sensitivity of the G-Sensor (2G is the most sensitive
setting only requiring small bumps to trigger recording,
and 8G is the least sensitive requiring a larger amount of
activity to trigger recording).
e. To confirm selection push the OK button, the KPT-500
will take you back to the SETUP menu.
12. Set Motion Detection
Motion Detection monitors on screen movement and will start
recording when movement is detected. Motion Detection will
also stop recording after 10 seconds of no on screen movement.