Karcher BD 55/60 W Ep Instructions Manual - Shutting Down The Appliance
English
23
Note
Carry out the initial cleaning attempts with
less contact pressure. Increase contact
pressure step-by-step until the desired
cleaning result is achieved. A correct set-
ting of the contact pressure reduces power
consumption and the wear and tear of the
brushes.
The brush motors come to a halt when the
machine stops and when there is overload.
몇
Warning
Floors can get damaged on account of too
high contact pressure. Carry out the initial
polishing attempts with less contact pres-
sure. Increase the contact pressure as per
requirements until the desired polishing re-
sult is achieved.
To improve the vacuuming result on tiled
floors the vacuum bar can be turned to an
oblique position of up to 5°.
Î Loosen crossh-handles.
Î Turn the vacuum bar.
Î Tighten the cross-handles.
If the vacuum result is unsatisfactory the in-
clination of the straight vacuum bar can be
modified.
Î Release the wing nuts.
Î Tilt the vacuum bar.
Î Tighten the wing nuts.
Î Close the regulatory button for setting
the water quantity.
Î Release the safety switch.
Î Lift the cleaning head.
Î Briefly drive forward and suck of the re-
maining water.
Î Raise the vacuum bar.
Î Apply parking brake (optional). Press
the pedal downwards and move it to the
right to lock it.
Î Turn the program selection switch to
"OFF".
Setting the Vacuum Bar
Oblique position
Inclination