Karcher DAB 2408 User Manual - page 28
28 - EN
6.
Press down on the Tune/Select
knob to confirm your setting. Next you can
select the alarm mode. Turn the Tune/Select knob to chose between buzzer
“BUZ”, “DAB” of “FM”:
7.
Press down on the Tune/Select
knob to confirm your setting. The alarm is
set.
If the alarm is set to buzzer, a bell ring will be activated for 60 minutes. If the
alarm is set to radio (DAB+ or FM) the previously selected station will be
played.
To switch off the alarm, press the Standby key.
To deactivate the alarm completely, repeat the above steps 1 - 3 and select
“OFF”.
1.2 Snooze
2
1
1.
To enable the Snooze function, press the Snooze key after the alarm starts.
The alarm will turn on every 5 minutes if the snooze function is activated.
2.
Press Standby key to cancel the Snooze function.
2. Sleep Timer
The sleep timer function enables you to set a countdown timer (5 - 60 minutes in 5
minute intervalls) after which the unit will switch off (Standby mode) automatically.
1.
To set the sleep timer enter the menu as described above and select the
“SLEEP” menu option.
2.
Enter the menu option by pressing down on the Tune/Select knob. Turn the
knob to select the desired time and press down on it once again to select
the time.
3.
The timer is set and the unit will switch to standby after the time is up.
4.
To deactivate the timer to avoid the automatic switch off, repeat steps 1 and
2 and select “OFF”.
3. System Reset
There may be times when you need to reset your receiver back to its original
factory settings, e.g. when you move the radio to another part of the country so
that you can pick up the local & national DAB+ stations in that area. If you don’t do
this, then when you select a station on the radio, it may no longer be available.
1.
Press and hold the Info/Menu key for 3 seconds to enter the menu.
2.
In FM mode the display will show “RESET” immediately. In DAB+ mode you
need to press the Info/Menu key once more to reach the reset option.
3.
Press down on the Tune/Select knob and the unit will be reset. This may