Karcher DAB 2410 User Manual - page 17
EN
EN - 17
FM Mode
1.
Power and switch on the radio as described above.
2.
Press the
MODE button to switch to FM mode.
3.
To automatically search for the next available radio station, press the
SCAN button.
To automatically search for the previous available radio station, press and briefly hold the
SCAN button.
The unit will search for the next/previous available station and stop automatically once a
station has been found.
4.
To manually search for a station, press the
◄ LEFT or ► RIGHT button repeatedly. Each
press adjusts the frequency by 0.05 MHz.
FM Menu
While in FM mode you can enter the main menu by pressing and holding for about 2 seconds
the
INFO/MENU button. Navigate through the menu and confirm settings as described above.
The menu options are the following:
< Factory Reset >
< FW Version >
Reset the product to
its factory settings (all
user settings will be
erased).
Shows the software
version currently
installed.
FM Display Modes
Every time you press the
INFO/MENU button in FM mode, the display will cycle through the
following display modes (shown in the bottom line of the display):
Radio Text, Program Type, Signal Strength, Time/Date, Frequency, Mode (Mono/Stereo).
Storing and Recalling Stored Stations (in DAB+ and FM Modes)
This function allows up to 10 stations to be programmed into the memory and stored in both
DAB+ and FM mode.
1.
To store a preset, first tune to your desired station (DAB+ or FM mode), then press and
hold the
PRESET button for 2 seconds. The display will show “Preset Empty 1” with the
“1” flashing.
2.
Press the
◄ LEFT or ► RIGHT button to select your desired station preset number.
3.
Press the
SELECT button to confirm your selection. The station currently broadcasting
has now been stored in the selected location.
4.
Repeat the above steps to store more stations.
5.
To select a preset station, first press the
PRESET button once and then press the ◄
LEFT or ► RIGHT button to scroll up or down the presets that you have stored, and
press the
SELECT button to confirm. If any preset has not been allocated “Preset Empty”
will be shown in the display.
Signal Strength & Quality
In both DAB+ and FM modes it is possible to display the signal strength. This is helpful when
setting up the radio and adjusting the antenna.
•
To display the signal strength in either DAB+ or FM mode, repeatedly press the
INFO/
MENU button until the display mode “Signal Strength“ is reached.