Karcher DR 40BT User Manual - Inserting Batteries
EN | 13
EN
Inserting Batteries
1. Loosen the screw with a
suitable screwdriver and take
off the battery lid.
2. Install 4 batteries “AAA”
size (not included). Mind the
remarks about batteries in
the chapter “Safety Informa-
tion” above.
3. Close the battery lid and
tighten the screw. Do not
overtighten it as this may lead
to damage of the unit.
Getting Started
Unit Setup
The unit can be positioned in several ways:
•
The unit has a
foldablestand on its back to place it on a table top or other surface.
•
To hang the unit onto a bar, a pipe, a hose or any other fixture, detach the handle from the
unit, place it on the fixture and attach the handle again to the unit.
•
The unit has a hanger on its back with which it can be attached to a nail, a hook or similar
items in the wall.
Switching the Unit On and Off and Basic Operation
•
To switch the unit on, press the STANDBY button.
•
To select between radio or Bluetooth
®
mode, press the FUNC/TIME-SET button repeatedly.
•
To increase or decrease the volume in either mode, press the VOL+ or VOL- button.
•
To switch the unit off, press the STANDBY button again. In standby model only the time will
be shown in the display.
Clock and Alarm Setting
Clock Setting
To set the time, the unit must be in standby mode.
1.
With the unit in standby mode, press the FUNC/TIME-SET button once. The hour will be
blinking.
2.
Set the current hour by pressing the SKIP+ or SKIP-
button. To confirm your setting, press
FUNC/TIME-SET button again. The minutes will be blinking.
3.
Set the current minutes by pressing the SKIP+ or SKIP-
button. To confirm your setting,
press FUNC/TIME-SET button again. The clock format will be blinking.
4.
Set the desired clock format (12h or 24h) by pressing the SKIP+ or SKIP-
button. To confirm
your setting, press FUNC/TIME-SET button again.