Karcher DR 40BT User Manual - Radio
14 | EN
5.
The clock is now set.
Alarm Setting
To set the alarm, the unit must be in standby mode.
1.
With the unit in standby mode, press and hold for 2 seconds the PLAY/AL-SET button until
the hour is blinking. At the same time the alarm symbol will be shown in the display.
2.
Set the hour of the desired alarm time by pressing the SKIP+ or SKIP-
button. To confirm
your setting, press PLAY/AL-SET button again. The minutes will be blinking.
3.
Set the minutes of the desired alarm time by pressing the SKIP+ or SKIP-
button. To confirm
your setting, press PLAY/AL-SET button again.
4.
The alarm time is now set and the display will switch back to normal clock display with the
alarm symbol showing as well.
5.
To select the alarm mode, press the PLAY/AL-SET button once while the unit is in standby
mode. Then press the PLAY/AL-SET button repeatedly to select between the following
modes:
Buzzer: Display shows “bU”. At the set alarm time, the buzzer will ring.
Radio: The display shows the radio frequency which has been selected last in radio mode.
At the set alarm time, the radio will switch on at the frequency last selected.
OFF: When OFF is selected, the alarm function will be deactivated and not come on at the
set time (the alarm symbol will disappear from the display).
6.
To turn off an activated alarm, press the STANDBY button once. The alarm will come on
again the next day at the set time, unless the alarm function deactivated (see step 5).
Radio
1.
Turn the unit on by pressing the STANDBY button.
2.
The unit will be in the mode last listened to (radio or Bluetooth
®
). If necessary, press the
FUNC/TIME-SET button to select the radio mode.
3.
To manually tune to a desired radio station, repeatedly press the SKIP+ or SKIP- button until
you reach the desired frequency.
4.
To automatically search for the next available radio station, press and hold for 2 seconds the
SKIP+ or SKIP- button.
5.
Set the desired volume by pressing the VOL+ or VOL- button.
6.
To switch the radio off, press the STANDBY button.
Bluetooth
®
Connection
Settings on the Unit
1.
Turn the unit on by pressing the STANDBY button.
2.
The unit will be in the mode last listened to (radio or Bluetooth
®
). If necessary, press the
FUNC/TIME-SET button to select the Bluetooth
®
mode (“bL” will be blinking in the display).
Settings on Your External Device
1.
Turn on the Bluetooth
®
feature on your device.
2.
Search for DR 40BT.
3.
Pair and connect to DR 40BT. If prompted for a password, enter “0000”.
4.
Pairing successful and ready to stream music.
Ready to Stream Music via Bluetooth
®
•
You can select a desired song directly from the DR 40BT by pressing the SKIP+ or SKIP-
button.
•
You can pause and resume playback directly from the DR 40BT by pressing the PLAY/