Karcher K 3000 G Operator's Manual - Vario Power Spray Wand

8  English

  Note: The actual appearance of the GFCI may 

be different from this illustration.

STEP 7:

  Unlock the trigger gun safety lock. Trigger the 

gun to eliminate trapped air, then wait for a 

steady flow of water to emerge from the spray 

nozzle.

STEP 8:

  Turn on the high pressure washer by turning 

the switch to the (I / ON) position.

  The motor runs only while the trigger of the 

gun is pulled and shuts off when the trigger 

is released.

STEP 5:

  Connect garden hose to the cold water source 

and turn water on completely.

STEP 6:

  Plug the Ground Fault Circuit Interrupter 

(GFCI) into a working outlet.

  We recommend that you test the GFCI as part 

of your startup procedure each time you use 

your pressure washer. Plug the GFCI into the 

outlet, press the reset button, press the test 

button and then press the reset button again.

WARNING

  Do not use if above test fails.

USING THE ACCESSORIES

WARNING

  To avoid serious injury, never point spray 

nozzle at yourself, other persons or animals.

  Always test an inconspicuous area before 

cleaning with high pressure.

Vario Power Spray Wand

 The Vario Power Spray Wand allows you to adjust 

the cleaning pressure.

To clean at maximum pressure, the wand must 

be positioned to the high pressure setting 

(Max).

OPERATING INSTRUCTIONS

For lower pressure turn the wand collar in the 

minus (Min) direction.

To apply detergent, the wand must be posi-

tioned to the lower pressure setting (Mix).