Karcher MC 6560 User Manual - page 24
24 | EN
3.
Press the TIMER button again, the MINUTE digit will start flashing, adjust it by pressing the
SKIP/TUNE SEARCH (UP or DOWN) button.
4.
Press the TIMER button once more to confirm and order TIMER ON time.
5. After adjusting “TIMER ON”, “
OFF” appears on the display and the HOUR digit flashes.(F2)
6.
Repeat the above steps 2 to 3, and then press the TIMER button once more to confirm and order
TIMER OFF time.
7.
Now the “TUNER” appears on the display with flashing, adjust “TUNER, CD, USB, SD CARD“ by
pressing the SKIP/TUNE SEARCH(UP or DOWN) button.
8.
Press the TIMER button again, the timer “VOL” indicator appears on the display and flashes,
adjust the timer volume high or low by pressing the TUNING/SKIP (UP or DOWN) button.
9. Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.
10. After adjusting “TIMER ON” and “TIMER OFF”, press the TIMER button, “ “ appears on the
display.
11. The unit will be switched on automatically at “TIMER ON” order and start playing, the unit will be
switched off automatically at “TIMER OFF” order.
Note:
If the display shows “ERROR” while you set the “TIMER ON”, it means both “TIMER ON” and
“TIMER OFF” is the same. In this case, please go to “TIMER OFF” to set the off time first.
EQ CONTROL (on the remote control)
EQ shows the present sound tone. When you press the EQ button , the sound tone changes as below:
TO SET SLEEP FUNCTION (on the remote control)
1. If you want to fall asleep to music, press the SLEEP button .
2. You may select the TUNER, CD/MP3, USB, SD/CARD or AUX mode in sleep function to play
from 90, 80, 70 up to10 minutes of music before shutting itself off automatically.
FUNCTION SELECT
The function is that when it presses the button the mode is changed. Display changes as below:
RADIO OPERATION
1. Press the FUNCTION button on the main unit (or remote control) to select the TUNER mode that
to select the FM operation.
2. Select the desired frequency with the SKIP/TUNE SEARCH(UP or DOWN) button on the main
unit (or remote control).
Mono/Stereo Select
This unit can receive FM frequency.
1. When you want to select FM stereo station, press the ID3/MO./ST. button once on the remote
control only. The “
“ indicator will appear on the display that the reception is at its best.
2. When you press the ID3/MO./ST. button once again, the FM STEREO indicator will turn off &
switch to MONO FM status.
Automatic Tuning
1. Press the SKIP/TUNE SEARCH (UP or DOWN) button for a few seconds, then release the but-