Karcher UR 1030 User Manual - page 13
EN
EN - 13
Clock Setting
1.
Power the unit as described above. The display will show “0:00” flashing.
2.
Press and hold the
CLK.ADJ button (2) for 2 seconds. The time will keep flashing.
3.
Press the
< TUNE DOWN / HOUR button (3) to set the hour and the > TUNE UP / MIN
button (4) to set the minutes.
Each press of the button will increase the hour or minute by one. Hold down the button to
quickly increase the hour or minute.
4.
Press the
CLK.ADJ button (2) again to confirm and store your set time.
Alarm Setting
This unit enables you to set 2 separate and independent alarm times.
1.
Ensure that the unit is in standby mode (i.e. radio is off).
2.
Press and hold for 2 seconds the
ALARM 1 On/Off (5) or ALARM 2 On/Off (6) button to
set either alarm 1 or alarm 2. The alarm time will be flashing in the display.
3.
Press the
< TUNE DOWN / HOUR button (3) to set the hour and the > TUNE UP / MIN
button (4) to set the minutes.
Each press of the button will increase the hour or minute by one. Hold down the button to
quickly increase the hour or minute.
4.
To toggle between Buzzer and Radio alarm modes and Alarm Off, repeatedly press
the
ALARM 1 On/Off (5) (or ALARM 2 On/Off (6)) button until the desired option is
highlighted on the LED display:
ALARM 1 Buzzer Indicator
ALARM 1 Radio Indicator
ALARM 2 Buzzer Indicator
ALARM 2 Radio Indicator
5.
Once the alarm is set, press the
ALARM 1 On/Off (5) (or ALARM 2 On/Off (6)) button
once to confirm your setting.
The unit switches back to clock display.
Notes:
•
If Radio is selected as alarm mode, the alarm will play the station last listened to. The
alarm volume will slowly increase until it reaches the volume that was last set in radio
mode.
•
In Buzzer alarm mode the volume of the buzzer is fixed.
Stopping an Alarm
To stop an active alarm, press the
ALARM Off button (1). The alarm will stop and come back on
again at the set time.