Karcher UR 1030 User Manual - page 14
14 - EN
Activating/Deactivating an Alarm
•
To deactivate a previously set alarm, repeatedly press the
ALARM 1 On/Off (5) (or
ALARM 2 On/Off (6)) button until Buzzer Indicator and Radio Indicator disappear from
the display. This alarm is now deactivated and will not ring.
•
To activate a previously set alarm, repeatedly press the
ALARM 1 On/Off (5) (or ALARM
2 On/Off (6)) button until Buzzer Indicator or Radio Indicator is shown in the display.
This alarm will now ring at the previously set time.
Snooze Function
The snooze function allows you to delay an active alarm for approximately 9 minutes. To do so,
press the
SNOOZE button (7) once while the alarm is active. The alarm will stop and come on
again after approximately 9 minutes.
To cancel this function, press the
ALARM Off button (1) once.
Radio
Listening to the Radio
•
Press the
POWER On/Off button (1) to switch on the radio.
•
Select a desired radio station by pressing the buttons
< TUNE DOWN (3) or > TUNE UP
(4) repeatedly.
•
To automatically search for the next available radio station, press and hold for 2 seconds
the buttons
< TUNE DOWN (3) or > TUNE UP (4).
•
To increase or decrease the volume, press the
VOLUME UP (6) or VOLUME DOWN (5)
button.
•
To switch the radio off, press the
POWER On/Off button (1).
Note: For the best FM reception completely unroll the FM wire antenna.
Radio Station Presets
1.
Press the
POWER On/Off button (1) to switch on the radio.
2.
Select a desired radio station using the buttons
< TUNE DOWN (3) or > TUNE UP (4).
3.
Press and hold the
MEMORY button (2) for 2 seconds. “P01” will flash in the display.
4.
Select a preset between 01 and 10 on which you would like to store the current station
using the buttons
< TUNE DOWN (3) or > TUNE UP (4).
5.
Press the
MEMORY button (2) again to store the station on the selected preset.
6.
Repeat steps 2 to 5 to store a total of up to 10 radio stations.
7.
To recall one of the stored stations press the
M+ button (2) repeatedly during radio mode
to select the desired preset.
Sleep Timer Function
The sleep function enables you to set a countdown timer after which the radio will turn itself off
automatically.
•
While listening to the radio, repeatedly press the
SLEEP button (7) to select a desired
countdown after which the radio will turn itself off automatically.
•
You can select 90, 80, 70, 60, 50, 40, 30, 20, or 10 minutes.
•
To check the remaining time on the countdown, press the
SLEEP button (7) once.
•
If you want to cancel the function and switch off the radio, press the
SLEEP button (7)
repeatedly until “OFF” appears in the display.