Karcher UR 1320BT User Manual - page 16
16 | EN
2.
“24H“ or “12H” will be flashing in the display. Select your desired time format by pressing the
Back or
Next button.
3.
Confirm your selection by pressing the
Clock Set button again. Now the hours are flashing.
4.
Set the current hours by pressing the
Back or
Next button.
5.
Confirm your setting by pressing the
Clock Set button again. Now the minutes are flashing.
6.
Set the current minutes by pressing the
Back or
Next button.
7.
Confirm your setting by pressing the
Clock Set button again. The time is now set.
Note:
•
When the clock is not set, the clock display will be flashing to indicate that the time needs to be
set.
Alarm Setting
The alarm function can only work properly, if the clock is set correctly.
1.
With the unit in standby mode, press and hold for 2 seconds the
Alarm button.
2.
The hour and “AL“ will be flashing in the display.
3.
Set the desired hours by pressing the
Back or
Next button.
4.
Confirm your setting by pressing the
Alarm button again. Now the minutes are flashing.
5.
Set the desired minutes by pressing the
Back or
Next button.
6.
Confirm your setting by pressing the
Alarm button again. The alarm time is now set.
Activating/Deactivating the Alarm & Alarm Mode
After you have set the alarm time, you need to activate the alarm:
1.
With the unit still in standby mode, press the
Alarm button once. The alarm time and “AL” will be
shown in the display. After approximately 5 seconds the display will switch back to normal clock
display, “AL” will remain in the display indicating that the alarm is active.
The buzzer will come on at the set alarm time.
2.
If you would like to be woken up by radio instead of buzzer, press the
Alarm button again while
the display is showing the clock and “AL”. The display will now show the set alarm time, “AL”
and a flashing “FM”. After approximately 5 seconds the display will switch back to normal clock
display, “AL” will remain in the display, while “FM” will disappear.
At the set alarm time, the unit will switch on to the last radio station played.
3.
To deactivate the alarm function, you need to press the
Alarm button twice if the alarm is set
to buzzer mode, or once if the alarm is set to radio mode. The set alarm time and “AL” will be
shown. After approximately 5 seconds the display will switch back to the clock display and “AL”
will disappear, indicating that the alarm is deactivated.
Note on the alarm volume:
•
When buzzer is set for wake up mode, it will come on with a slowly increasing volume.
•
When radio is set for wake up mode, it will come on at volume 15 if the previously set volume
during radio mode was 15 or below. If a higher volume level than 15 was set, it will come on at
this set volume.
Stopping an Active Alarm
To stop an active alarm, press the
On/Standby button. The alarm will come back on the next day
at the set alarm time.
Snooze Function
The snooze function allows you to delay an active alarm for 9 minutes. To do so, press the
Snooze
button once while the alarm is active. The alarm will stop and come on again after 9 minutes.
The procedure can be repeated for approxiamtely one hour.
Sleep Function
The sleep function enables you to set a countdown timer after which the unit will turn itself into standby
mode automatically.
•
At any time while the unit is operating, press and hold for 2 - 3 seconds the
Sleep button to ac-