Karlyn 20103 Owner's Manual - Turn of The Century
6
Turn of the Century
TM
ASSEMBLY INSTRUCTIONS
5
6
5. Assemble the canopy cover to the bottom of the
canopy. Then, feed the wires coming from the motor
adapter through the adapter cover, canopy trim ring,
canopy and downrod.
6. Insert the downrod into the motor adapter and
reinstall the downrod pin and downrod clip. Then
retighten the set screws.
Note:
Laying the fan assembly on its side during this
step will make access to the set screws easier.
Downrod
Canopy
Adapter Cover
Canopy Trim Ring
Downrod Pin
Motor Adapter
Downrod
Set Screw
Downrod Clip
Motor Adapter
7. With wiring extending out of the downrod, measure
8 inches of lead wire and cut the excess wire with wire
cutters (not included). Strip 1/2” of insulation from the end
of each wire. Then, lift the downrod into the mounting
bracket. Rotate the downrod until the tab in the mounting
bracket is seated in the slot in the downrod ball.
Tab
Slot
Downrod
Mounting
Bracket
7
Black (Hot)
Wire Connector
White (Neutral)
Bare/Green (Ground)
Black
Blue
White
Green
8. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white (neutral/
common) supply wire.
• Connect the black and blue wires from the fan to the
black (hot) supply wire.
• Connect the green wire from the fan to the bare/green
(ground) supply wire.
Note:
If a second hot/power supply wire is available from
the outlet box, connect it to the blue fan wire (light power)
for separate light and fan control.
Important:
After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
8