Karlyn 20103 Owner's Manual - Turn of The Century
7
Turn of the Century
TM
ASSEMBLY INSTRUCTIONS
10
9. Raise the canopy, ensuring the two mounting
bracket screws are aligned with the L-shaped slots in
the canopy. Then turn the canopy counter clockwise
until the mounting bracket screws are completely
engaged in the L-shaped slots. Install the two
previously removed mounting bracket screws in
the round holes. Securely tighten all four mounting
bracket screws.
Then, raise the trim ring over the canopy and turn
clockwise so the heads of the mounting bracket
screws are seated in the rails inside the trim ring.
10. Attach the blades to blade arms using the blade
screws, washers and screw caps from the hardware kit.
Note:
Blade arms have a label that indicates which
side faces the motor. The blade attaches to the
opposite side of the blade arm.
9
Canopy
Trim Ring
L-shaped
Slot
Round
Hole
Blade
Arm
Screw Caps
Blade Screw
Washer
Blade
Label
Mounting
Bracket Screw
Blade Arm
Motor Screw
Blade Isolator
Motor
Slot
Motor
Screw
11. Remove the motor screws and washers from the
bottom of the motor using a magnetic Phillips screwdriver.
Note:
The slot in the light kit allows access to motor
screws with screwdriver.
11
12. With spring washers on motor screws, place the two
motor screws through the holes in the blade arms. Then
attach the blade isolator on the screws.
Note:
The blade isolator should hold the screws and
washers in place while installing the blade arms to motor.
Attach the blade arm assembly to the underside of
the motor by securing the motor screws with a Phillips
screwdriver. Completely secure each blade arm to motor
before moving to the next.
12