Karmann Ontario Operating Instructions Manual - page 30

D 

FURNITURE Ontario 635 (SIDE SEATING AREA)

D 

Table in seating group

4-3

Safety belts in the

seating group

Lower tabletop

Lift the table slightly at the front edge.

Pull the table leg downwards and

hinge it backwards. then lift the

tabletop out of the guide rail and lay it

on the bench rails. 

In order to return the table to its

original position, click it into the guide

rail and hinge the table leg down.

Caution

Make sure that the table is correctly

clicked in. If so, red knob A projects.

Extending tabletop

The Ontario 635 has an extending

tabletop in the found seating group. In

order to pull out the table, lift the

tabletop slightly and pull it back to the

stop. The extra leaf for the table is on

the floor of the wardrobe.

Caution

Push in the table during travel and

secure the extra leaf in the holder in

the wardrobe.

The seating group is fitted with two

three-point automatic seat belts as

standard, facing in the direction of

travel. Further automatic belts

(against the direction of travel) may

be purchased as optional extras.

Lap belts can be purchased as

optional extras to be used against the

direction of travel.

Note

Belts built in subsequently may only

be fixed at the points provided on the

benches. A maximum of two

complete belts can be installed at

each bench.

Installation should be carried out by

an approved dealer.

A