Kathy Ireland Total Body WLEL42070 User Manual - page 10
10
HOW TO EXERCISE ON THE ELLIPTICAL
EXERCISER
To mount the elliptical exerciser, hold the handlebars
and step onto the pedal that is in the lowest position.
Next, step onto the other pedal. Push the pedals until
they begin to move with a continuous motion. Note:
The crank can turn in either direction; it is recom-
mended that you turn the crank in the direction
shown at the right; however, to give variety to
your exercise, you may choose to turn the crank
in the opposite direction.
To dismount the elliptical exerciser, allow the pedals
to slowly come to a stop. CAUTION: The elliptical
exerciser does not have a freewheel; the pedals
will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest
pedal first. Then, step off the lowest pedal.
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
The elliptical exerciser can be cleaned with a soft,
damp cloth. Keep liquid away from the electronic
monitor. Keep the monitor out of direct sunlight or the
display may be damaged. Remove the batteries when
storing the elliptical exerciser.
CONSOLE TROUBLE-SHOOTING
If the console does not function properly, the batteries
should be replaced. See assembly step 5 on page 7
for instructions. In addition, make sure that the sensor
wire is connected to the wire on the monitor. See
assembly step 1 on page 6.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. You will need to
remove the left shield from the elliptical exerciser (see
HOW TO REMOVE THE SHIELDS on page 11).
Locate the Reed
Switch (48).
Turn the Fan
(31) until the
Magnet (52) is
aligned with the
Reed Switch.
Loosen, but do
not remove, the
M4 x 16mm
Screw (19).
Slide the Reed
Switch slightly closer to or farther away from the
Magnet. Make sure that the Magnet will not hit the
Reed Switch. Retighten the Screw. Turn the Fan for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the left shield and the crank arm.
Pedal
Crank
MAINTENANCE AND TROUBLE-SHOOTING
48
52
31
19