KCorp LifeStyle Silver Series KLS-611 User Manual - page 5
Chapter 3- Installation for Windows platform
The following section will assist you in installing your wireless LAN Adapter successfully. You will first install software
(Utility) and then insert / attach the Wireless LAN Adapter to your system, and finally set the network properties to
accommodate resource sharing and select the type of wireless network that you wish to install. The Wireless LAN card
can easily be installed and used, without bothering to connect cables for keeping your comuter to use network resources.
3.1. Installation Overview
Here are the steps to perform in order to establish your wireless network connection:
Install the Access Point first. AP is needed in case of Infrastructure network mode.
Install the software using the Install CD.
Insert the Wireless LAN 802.11g Adapter.,
Install the network protocol(s) required to communicate on your network. Most likely you will need the TCP/IP
protocol (present by default on most Windows machines)
3.2. Install Procedure for Windows XP
Note:
Do not physically insert the
WLAN Adapter
until you are asked to do so, failure of which may result in
unsuccessful installation of your
WLAN device
.
1.Insert the given Installation CD in the CD-ROM and then click on the picture of the adapter you have.
Follow the instructions to complete the installation.
2. Insert your WLAN card into PCMCIA/PCI slot or USB connector of your system, and let the system detect the new
hardware.
Select
“Install the software automatically (Recommended) ”
, and then click
Next
to continue.
Once your system detected the driver, Microsoft will show a warning message as below.
5
3- Installation for Windows platform