KDDI P001 User Manual - page 53
51
T
roub
leshooting/Appendix
Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
FCC RF Exposure Information
■
THIS MODEL CELL PHONE MEETS THE
U.S. GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your cell phone is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission (FCC) of the United
States (U.S.) Government.
The guidelines are based on standards that were
developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to
assure the safety of all persons, regardless of age and health.
The exposure standard for wireless cell phones employs
a unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg*.
The tests are performed in positions and locations (e.g. at
the ear and worn on the body) as required by the FCC for
each model.
The highest SAR value for this model cell phone when
tested for use at the ear is 0.559 W/kg and when worn on
the body, as described in this user guide, is 0.544 W/kg.
Body-worn Operation; This device was tested for typical
body-worn operations with the back of the cell phone
kept 1.5 cm from the body. To maintain compliance with
FCC RF exposure requirements, use accessories that
maintain a 1.5 cm separation distance between the user’s
body and the back of the cell phone. The use of beltclips,
holsters and similar accessories should not contain metallic
components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with
FCC RF exposure requirements, and should be avoided.
The FCC has granted an Equipment Authorisation for this
model cell phone with all reported SAR levels evaluated as
in compliance with the FCC RF emission guidelines. SAR
information on this model cell phone is on file with the FCC
and can be found under the Display Grant section of
http://www.fcc.gov/oet/ea/ after searching on FCC ID
WV2108001A.
Additional information on Specific Absorption Rates (SAR)
can be found on the Cellular Telecommunications & Internet
Association (CTIA) website at http://www.phonefacts.net.
* In the United States, the SAR limit for wireless cell phones
used by the public is 1.6 watts/kg (W/kg) averaged over
one gram of tissue. SAR values may vary depending upon
national reporting requirements and the network band.