Kedacom IPC2251-AN Quick Start Manual - page 13
3
Picture 4
2. Connect cables and power on. Different sub models have different connector interface. Take the model with
the most connectors as example, and the tag meanings are explained in Picture 4:
System for client installation:
Processor: 2.0 GHz CORE®2 series or other equivalent processors
RAM Memory: 2GB or above
Operating System: Windows XP or newer version
Browser: IE6.0 or newer version
DirectX
:9.0c
3. Login client
[Note]:
This Guide will take Windows XP as example to explain client login steps.
1) The factory default IP of camera is 0.0.0.0. Please set the camera and the PC in the same LAN and use
IPCSearch to configure IP. If the network provides DHCP service, DHCP server will configure IP for the
camera automatically.
2) Run IPCSearch, select the target camera, and click Modify Params. When configure a static IP for the
camera, please check “Custom device address (Close DHCP)” and fill the Ethernet parameter. After
configuration, the camera will reboot automatically and this takes 60s.
DC12V
DC12V IN
CVBS Output
ALARM IN
LINE
IN
LINE OUT
Rs485 Port
Connect
to surveillance keyboard or alarm expander
KEDACOM
KEDACOM
ALARM
OUT
KEDACOM
PICKUP
Connect
cables as indicated
Cut
off terminal and connect
10/100M
Adaptive
Client
Rubber
Cushion
Rubber
Ring
Water-proof part of the cable, must be installed and tightened.
Steps:
2
1
Route
the cable
Make a Rj45
connector