KEENCUT Evolution E2 User Instructions - 4.1
4.1
Operation
4.1
INSERT AND ALIGN THE MATERIAL
Use one of the two Lift Handles to raise the Cutter Bar. With the cutter bar raised place
the material to be cut on the Base. Lower the Cutter Bar by pushing the Lift Handle
towards the cutting edge of the machine. To align the edge of the cutter bar with your
cutting marks slightly raising the Cutter Bar, using the Lift Handle, and adjust the posi-
tion of the board at each end. The blade will cut within 0.5 to 1mm [0.02" to 0.04"] of
the sight edge; this small gap allows easier alignment when cutting to the edge of an
image.
Check that the width of the Cutter Bar is laying flat on the surface of the material, if not
loosen both Tilt Adjustment Knobs "
G
" & "
F
" then lift the Cutter Bar and lower it down
again to settle it in position and tighten both "
G
" & "
F
". The cutter is now set for cut-
ting all types of material of that thickness.
The flip over Material Stop "
H
" is provided to prevent tough materials such as PVC
Foamboard from moving during cutting.
➤
➤
NOTE: If you are cutting a small piece of
board place it at right hand end of the Cutter Bar
against the Material Stop and place scraps of the
same thickness material under the remaining
bar to support it and prevent sagging.
G
➤
F
H
G