KEENCUT Evolution E2 User Instructions - 2.1
2.1
Before Set Up 2.1
Overall length of cutter
Worktop
9.5cm
Overall length of cutter
Worktop
15cm
24.5cm
9.5cm
Evolution E2 160cm
(64”) overall length 193cm (74”)
4 base fixing brackets
Ev
olution E2 210cm (84”) overall length 243cm (94”)
5 base fixing brackets
Evolution E2 260cm
(104”) overall length 293cm (114”)
6 base fixing brackets
Evolution
E2 310cm (124”) overall length 343cm (133”)
7 base fixing brackets
Evolution E2 360cm (144”)
overall length 393cm (153”)
8 base fixing brackets
CHECKING THE BENCH FOR INSTALLATION
Please note!
As part of the installation there are a number of checks and
adjustments to be made and it is important to perform them correctly to ensure
consistent top quality performance for the life of the machine.
The Evolution E2 Cutter Bar can be fixed to a KEENCUT Proteus bench or to an existing
work bench. The bench should be rigid with a flat worktop (within 3mm (1/8") overall)
and made from MDF or similar material to accept fixing screws.
To enable the flip-over storage function to operate the Evolution E2 must be fitted close
to the edge of the bench but if it is required nearer the centre of the bench do remember
that cutting tough materials will be more difficult if the operator needs to stretch too far
to reach the cutter head.
If the cutter is to be mounted along the edge of the bench draw a line 9.5cm in from the
edge of the worktop and the length of the cutter as listed below.
Should you want to use the cutter, for example 15cm in from the edge, draw the line
15 + 9.5 = 24.5cm from the edge of the worktop.