KeepRite K40-CU-IM-13 Installation And Maintenance Instructions Manual - Start-Up Information
35
Start-up Information
Important: This start-up information should be completely filled in on each installation and remain with the unit
as a permanent record for future reference. Future service work may be logged on the proceeding page. Service
parts list are attached to the back cover. PLEASE PRINT LEGIBLY
Name & address of installation___
___________________________________________________
__________________________________________________________________________
Name, address, phone & fax # of Installing contractor _____
__________________________________
__________________________________________________________________________
__________________________________________________________________________
Type of System (Cooler, Freezer, etc…) ___________ Design Box Temperature
_____
o
F
Condensing
Unit
System
start-up
date
______________________
Unit model # _________________________________ Unit serial #
____________________________
Compressor model #___________________________ Compressor serial #
_______________________
Evaporator(s)
QTY ______
Unit model #
____________________________
Unit serial #
____________________________
Unit model #
____________________________
Unit serial #
____________________________
Evaporator(s) unit electrical rating:
Volts__________Phase__________Hz
__________
Voltage at evaporator terminals: L1/L2___________
L2/L3
____________
L1/L3
__________
Amperage at evaporator:
L1___________ L2____________ L3______________
Expansion valve - Manufacturer________________________________ Model #
____________________
Evaporator drain line trapped outside of box____Yes
_____No
System Conditions
(Record just before desired box temperature is reached)
Refrigerant Type________Total Charge________System evacuation # of times______Final micron
_______
Ambient at start-up ______
o
F Operating box temperature
______
o
F
Thermostat setting ______
o
F Defrost settings ______ / day
Minutes fail safe
______
Condensing unit electrical rating:
Volts__________Phase__________Hz
__________
Voltage at compressor terminals:
L1/L2___________ L2/L3 ____________ L1/L3
__________
Amperage at compressor:
L1___________ L2 ____________ L3
___________
Compressor discharge pressure__________psig
Compressor suction pressure
__________
psig
Discharge line temperature at compressor
______
o
F
Suction line temperature at compressor______
o
F
Superheat at compressor
___
o
F
Suction line temperature at evaporator TX valve bulb______
o
F Superheat at evaporator
______
o
F
Comments:________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________
__________________________________________________________________________