Keetouch KOT-0121US-SA6BP User Manual - page 7
19" LCD Open frame SAW TM
(the Dust T-proof type)User Guide (Rev2.0)
- 7 -
NOTE:Do not penitrate the M4 screw into the monitor more than 5mm.
2.5 Interface Connection
Note: Before connecting the cables to your touchmonitor and PC, be sure that the
computer and touchmonitor are turned off.
1. Connect one end of either the serial (RS232) cable or the USB cable(but not both) to the
rear side of the computer and the other end to the LCD monitor. Tighten by turning the two
thumb screws clockwise to ensure proper grounding ( USB cable does not have thumb
screws).
2. Connect one end of the video cable to the rear side of computer and the other to the LCD
monitor. Tighten by turning the two thumb screws clockwise to ensure proper grounding.
3. Connect one end of the power adapter to the monitor and the other end to the connector of
the power cord.
4. Press the power button on the rear panel to turn the monitor power on.