Keiser MM5050 User Manual - Maintenance
Maintenance
11
Note: There is no need to adjust this product upon delivery.
When using this product commercially, periodically lubricate the inside of walking belt with
silicon oil. Most problems can be solved by following the steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, please let us know.
HOW TO MOVE THE TREKMILL
Before moving the TrekMill, change the grade of the TrekMill to the lowest level and
unplug the power cord.
Tilt the TrekMill back until it rolls freely on the wheels. The help of a second person may be needed when
tipping the TrekMill. Carefully move the TrekMill to the desired location. Place one foot on the walking belt,
and carefully lower the TrekMill until it is resting on the floor. Never move the TrekMill without tipping it back.
To reduce the risk of injury, use extreme caution while moving the TrekMill. Do not attempt to move the
TrekMill over an uneven surface.
TROUBLE SHOOTING
The power does not turn on.
1.
Make sure the power cord is plugged in.
2.
Make sure the power supply is the correct voltage.
3.
Make sure the on/off switch is in the "on" position.
The power turns off during use.
1.
Check the circuit breaker located on the TrekMill near the power cord. If the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
2.
Make sure the power cord is plugged in.
3.
Remove the key from the console. Reinsert the key back into the console.
4.
Make sure the on/off switch is in the "on" position.
The walking belt slows when walked on.
If the belt is over tightened, the TrekMill performance may decrease and
walking belt may become damaged. Remove the key, and UNPLUG THE
POWER CORD. Using the supplied Allen wrench, turn both rear roller
adjustment bolts counterclockwise 1/4 turn. When the walking belt is
correctly tightened, you should be able to lift each side of the walking belt
2 to 2.75 in (5 to 7 cm) off the walking platform. Be careful to keep the
walking belt centered. Plug in the power cord, inset the key and carefully
walk on the TrekMill for a few minutes. Repeat until the walking belt is
properly tightened.