Keithley 2910 Quick Start Manual - page 12
2910-VSG Vector Signal Generator Quick Start Guide
2910-903-01 Rev. A / February 2006
2
Unpacking and inspecting the system
Inspection for damage
After unpacking the Model 2910, carefully inspect the unit for any shipping damage. Report any
damage to the shipping agent immediately, as such damage is not covered by the warranty.
Shipment contents
The following items are included with every Model 2910 order:
•
CD-ROM with software, drivers, and 2910-VSG help
•
Power line cord
•
Safety standard card
•
Quick start guide
•
Calibration certificate
One of the following models:
•
Model 2910-F Front RF output with bench-top bumpers and handles
•
Model 2910-R Rear RF output with bench-top bumpers and handles
•
Model 2910-FRK Front RF output with rack-mount kit
•
Model 2910-RRK Rear RF output with rack-mount kit
The following items are options than can be ordered for the Model 2910:
•
Model 2910-GSM GSM/GPRS/EDGE Signal Generation Personality
•
Model 2910-CDMA2000 CDMAOne/2000 Signal Generator Personality
•
Model 2910-WCDMA W-CDMA Signal Generator Personality
•
Model 2910-LPN Low-Phase Noise
•
Model 2910-ARB 64 M-Sample Arbitrary Waveform Generator (ARB)
•
Model 2910-ADAPTER-KIT RF Cables and RF connector Adapters
Type-N Male to Type-N Male cable (quantity 2, length 1M)
SMB Male to SMB Male cable (quantity 2, length 1M)
SMB Male to SMB Male cable (quantity 2, length 0.3M)
SMB Male to BNC Male cable (quantity 4, length 1M)
BNC Male to BNC Male cable (quantity 2, length 1M)
Type-N Male to SMA Female adapter (quantity 2)
USB Host to USB Device cable (quantity 1, length 1M)
Carry case (quantity 1)
•
Model 2910-DCBLOCK External DC Block
•
Model 2910-RMK Rack-mount Kit with flanges
•
Model 2910-BENCH-KIT Bench-top Kit with bumpers and handles
•
Factory Calibration Report of Instrument Calibration Data
Repacking for return shipment
Should it become necessary to return the Model 2910 for repair, carefully pack the entire unit in its
original packing carton or the equivalent, and perform the following steps:
•
Contact Keithley to get a Return Material Authorization (RMA). You can contact Keithley
through your local Keithley representative, or by calling the Keithley factory at 1-888-534-8453
(1-888-KEITHLEY), or through the Keithley Web page at www.keithley.com.
•
On the shipping label, write ATTENTION REPAIR DEPARTMENT, and the RMA number.
Warranty and contact information is located at the front of this manual.