Keithley 8009 Instruction Manual - page 12
1.1
Introduction
This packing list contains information on using the Model 8009 Resistivity Test
Fixture. The Model 8009 allows volume resistivity measurements up to 10
18
ohm-cm or surface resistivity measurements up to 10
17
Ω
. The test fixture is
designed using a three-lug triax connector that allows simple connection to a
Keithley Instruments Model 6517, 6517A, or Model 6517B Electrometer.
NOTE
All references in this manual to the Keithley Instruments
Model 6517 are also valid for the Model 6517A.
Model 8009 features
All electrodes made from stainless steel for corrosion prevention.
Switchable volume/surface resistivity modes.
Operates with Keithley Instruments Model 6517 and Model 6517B Electrometer/
High Resistance Meters.
Safety interlock system and dual safety banana jacks for connection to 1kV
source in Model 6517 and Model 6517B.
1.2
Supplied accessories
The following accessories are supplied with the Model 8009 test fixture:
•
Model 6517-ILC-3:
3- meter, 4-pin interlock cable.
•
Model 6517B-ILC-3:
3- meter, 4-pin interlock cable.
•
Model 7078-TRX-3:
A 3 ft. (0.9m) low noise triaxial cable that is
1
General Information
iv
1