Kellyco MPX Digital Owner's manual - page 4
TARGET ID GUIDE —
At the top of the control panel is an easy to read graph indicating
targets for use with the Target Icons on the lower scale of the LCD.
4
OPERATION OF CONTROLS —
Power ON and OFF Button
Press the
POWER BUTTON ONCE to turn the MP
X
ON.
NOTE: Pressing the POWER BUTTON TWICE will turn the
MP
X
OFF
9
IN THE FIELD TIP FOR USING YOUR MP
X
—
2. The MP
X
is an Ultra Slow Motion Metal De-
tector. When using this detector the coil must be
in motion to detect any target. A sweep speed
of about 2 feet per second is perfect. You can
hunt as fast as you want or your pace dictates.
3. The coil is water resistant and can
be used around water, however be
careful not to get water into the control
housing.
4. Correct arm
position. Adjust
the lower stem
so that your arm
is hanging in a
comfortable posi-
tion by your side
with the coil
about 1 inch off
the ground.
1. Always keep the bottom of the coil
level with the ground. Try to maintain coil
1 inch off the ground at all times. You do not
need to scrub the ground with the coil.
USING THE HEADPHONE JACK —
To bypass the built-in audio speaker you can simply plug in any 1/4 inch stereo head-
phone jack and now you will only get audio from the headset. By using the headset
you will be able to hear the fainter targets. Another benefit of using headphones is
that it will decrease the battery usage in the audio circuit. Always use headphones
designed for metal detector use.
Installing the Batteries:
Remove the battery compartment cover and
install two (2) 9-volt batteries. Make the correct connections between the new batter-
ies and ensure the battery snaps are plugged in. Replace the battery cover.
PUSH DOOR TAB IN TO REMOVE
BATTERY DOOR COVER
(Back of Control Box)
1/4" HEADPHONE JACK
*Automatic Low Battery Indicator: When you see 1 or even 2 low battery icons,
it's time to replace one or both of the batteries.
2
FEET
PER
SECOND