Kelty KIDS CONVERTIBLE Instruction Manual - page 5
10
CONVERTIBLE ADJUSTMENT
CHILD’S COCKPIT ADJUSTMENT
H. Adjust the leg straps so they fit comfortably over the child’s legs by
tightening or loosening the leg strap webbing on the back of the cockpit
(Figure 3H). Make sure the leg straps are not binding or pinching the
child’s legs.
E. Place child’s shoulder harness over child’s shoulders.
F. Attach the side-release buckles, sewn to the child’s shoulder harness to
the mating buckles on the silver webbing sewn to the child’s chest pad.
G. The child’s shoulder harness can be adjusted up or down by sliding it on
the webbing at the back of the child’s seat (Figure 3G). Adjust the
harness so the padded section lies smoothly over the child’s shoulders.
Figure 3G
Figure 3H
9
CONVERTIBLE ADJUSTMENT
CHILD’S COCKPIT ADJUSTMENT
D. Place child into cockpit. Make sure both legs go through leg openings
(Figure 3E and 3F).
NOTE: Your child’s legs must go under the padded, silver
leg straps.
C. Adjust the cockpit seat height by attaching the two snap-hooks to the
desired steel rings at the front of cockpit (Figure 3D). There are three
sets of steel rings for seat-height adjustment. To raise the seat height,
attach to the upper seat rings. To lower, attach to the lower rings.
Figure 3E
Figure 3F
Figure 3D