Kelvinator KHBF336HWF Instruction Book - Trouble Shooting
46
GB
Regular cleaning
Clean the equipment regularly.
Don't use detergents, abrasive or strongly odor-
ous cleaners, waxy polishing agents or disinfec-
tants or alkoholic products for cleaning the equipment.
Before cleaning pull out the wall plug of the equipment from
the outlet.
Internal cleaning
Clean the internal parts of the equipment and the acces-
sories with warm water and sodium bicarbonate (5 ml to 0.5
litre of water).
Rinse and dry everything thoroughly.
Clean the door seal profile with clean water.
External cleaning
Clean the external parts of the equipment with warm water
and sodium bicarbonate (5 ml to 0.5 litre of water).
It is recommended to remove the dust and dirt deposited on
the back side of the equipment and on the condenser once
or twice a year, and to clean the evaporation tray on top of
the compressor.
After cleaning, reconnect the equipment to the mains sup-
ply.
When the refrigerator is not in use
In case the appliance will not be used for a long time follow
these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the cover
in the direction indicated by the arrow (2). So the bulb can
be replaced. (Bulb type: T 25 230-240 V, 25 W, E 14
thread)
After changing the bulb replace the cover, snap it in place
and apply voltage to the appliance.
If something does not work
During operation of the appliance some smaller but annoy-
ing trouble can often occur, which does not require calling
a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with
certain sounds (compressor- and circulating sound). This is
not trouble, but means normal operation.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of com-
pressor does not mean being no-current. That is why you
must not touch the electrical parts of the appliance before
breaking the circuit.