Kemp LoadMaster LM-2400 User Manual
User manual for LM-2400
Generel
First we congratulate you with your new LM-2400 Environment control.
LM-2400 Environment control is adjusted to the Roltec Vision wheel chair so the environment can be ope-
rated the same way as the wheel chair ex electrical lift or electrical back.
LM-2400 Environment control is compatible with GEWA “Smart House” system, as to understand that the
LM-2400 can be preset to GEWA “Smart House” system.
Operation
LM-2400 operates from the wheel chairs joystick and display. The control itself is the same as like ex the
foot rest etc. Meaning you choose the function in the display menu.
In the menu you fi nd a function “environment”. This is the access to the LM-2400 environment control. You
choose the function by moving the joystick forward.
Here you enter a new menu where the environment is divided into 2 groups, ex television, stereo etc. If you
choose one of the groups, you enter each choice
ex the choice “television” :
•
On/Off
•
Sound up/down
•
Channel up/down
Programming
Serial port
programming switch Reset Preset
Loading of other remote controls
The programming switch activates and the red light diode turns on as an indication of the LM-2400 is in the
programming mode.
First you choose the function which shall be programmed, this is done by choosing the function in the Rol-
tec wheel chairs menu.
When the function is chosen, a red light diode turns on in the front of LM-2400. This means that now the
wanted function can be loaded. This is done by pointing the control box against the front of the LM-2400.
A distance of 5 cm. will be appropriated. The wanted function activates and keeps activated until the light
diode in the front turns off.
The light diode in the front turns on again a second time to confi rm the code is read correctly.
Activate the environment control an extra time with the actual function.
If the code is read correctly the light diode will make a quick fl ash. If there is any errors, the light diode will
make a “long” fl ash.
The programming is ended by activating the programming switch, and the red light diode turns off.