Kemp LoadMaster LM-2400 User Manual - page 2
Programming example:
1. Press the programming button
2. Activate the function at the joystick box. A small red LED will light in the window at the
enviroment control.
3. Activate the function at the remote control.
4. The red LED at the remote contron turnes off.
5. Release the button on the remote control
6. The LED at the enviroment control lights up again
7. Press the button on the remote control again
8. The LED at the enviroment control turnes off again
9. Release the button on the remote control
10. The LED in the enviroment control gives a quick fl ash (= OK)
11. The LED in the enviroment control gives a slow fl ash (= FAULT)
12. Finaly, press the programming button
Preset the channels
When you make a preset, you preset the channel wanted in the LM-2400 environment control to GEWA
“Smart House” system.
This is done by activating the preset switch. The green light diode turns on as an indication of preset is cho-
sen.
The channel you want to be preset is chosen with the Roltec wheel chairs joystick. The preset mode is ended
with an activation of the preset switch, and the green light diode turns off.
Reset
With the reset switch you can reset the complete system, but without deleting the loaded codes.
This is a very usefull function in the case that you ex want to stop in the middle of a programming situation.