Kemppi MASTERTIG AC/DC 2000 Operation Instructions Manual - 6.  Accessories

Mastertig AC/DC 2000, 2500, 2500W, 3500W/0510 – 23

© 

COPYRIGHT

KEMPPI

OY

C 100C

C 100D 

C 100AC

6.  ACCESSORIES

6.1.  REMOTE CONTROL UNITS

C 100C 

Control of MMA / TIG welding current, memory scale 1 - 10.

C 100D 

Control and fine-tuning of MMA / TIG welding current, memory scale 1 - 10.

C 100AC  Control of MMA / TIG welding current, memory scale 1 - 10 and MMA / 

TIG selection.

C 100F 

Foot pedal control unit for TIG welding 

–  start function 

–  adjustment of the welding current with pedal movements 

–  limitation of the welding-current range with min and max potentiometers

6.1.1.  Connecting the foot pedal unit:

The foot pedal unit has two connections, which are connected 

to the remote control and start connections in the rear of the 

power source. When using the foot pedal unit, the 

maximum current output of the machine is ca. 30 % 

below its maximum output unless the machine is calibrated for 

the foot pedal unit. 

6.1.2.  Calibration of the machine for the foot pedal unit:

1.  Turn the machine off.

2.  Press the REMOTE key and at the same time turn the machine on; the display will show 

  the text rEn 01.

3.  Turn the current adjustment knob so that the display will show rEn 02. (01=C 100C, 02=C 100F)

4.  Press the REMOTE key so that the setting is saved in the memory.

6.2.  WHEEL BARROWS AND TRANSPORT CHASSISES

T 120 (transport unit)

Mastertig AC/DC 2000, 2500, 2500W, 3500W

lifting ear

Do not lift the welding machine and 

the transport unit with a gas bottle.

T 22 (transport unit)

Mastertig AC/DC 

2500, 2500W, 3500W

lifting ears 

on both sides 

(total  4 pcs)