Kenmore 30" Installation Instructions Manual
1
KENMORE ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
(and Optional Electric or Gas Cooktop Combination)
B
A
D
C
H
F
I
G
27 3/16”
(69.1 cm)
1¼”
(3.2 cm)
Min.
31”*
(78.7 cm)
3”
(7.6 cm)
1” (2.5 cm)
Min.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make
the job of installing easier. The first step of your installation should be to measure your
current cutout dimensions and compare them to the cutout dimensions chart below for
your model. You may find little or no cabinet work being necessary.
Figure 1
27" and 30" Single Wall Ovens (Double ovens see Figure 2)
P/N 318201531 (0905) Rev. A
English – pages 1-8
All dimensions are in inches (cm).
Do not remove spacers (if equipped) on the side walls and/or on the back of the built-
in oven. These spacers center the oven in the space provided. The oven must be centered to prevent
excess heat buildup that may result in heat damage or fire.
2" (5cm) Wide Wood
Spacer if Needed
NOTES:
1. Base must be capable of supporting 150 pounds (68 kg) for 27" models
and 200 pounds (90 kg) for 30" models.
2. Allow at least 21" (53.3cm) clearance in front of oven for door
depth when it is open.
3. Dimension G (cutout depth)is critical
to the proper installation of the built-in
oven. If the oven decorative trim does
not butt against the cabinet, or if noise
is heard on convection models, verify
dimension G to assure it is the required
* Suggested distance from floor is 31" (78.7cm).
Minimum required distance is 4½" (11.4cm)
Door Open
(see note 2)
Spacer
Electrical
Junction Box
Hole
for Cable
depth.
4. For a cutout height greater than
27
13
/
16
"
(70.6cm) add one 2"
(5cm) wide wood shim of
appropriate height to each
side of the opening under the
appliance side rails.
Printed in United States
United States
Canada
PRODUCT DIMENSIONS
MODEL
A
B
C
D
27" (68.6cm)
27 (68.6)
29
1
/
16
(73.8)
24
5
/
8
(62.5)
24½ (62.2)
30" (76.2cm)
30 (76.2)
29
1
/
16
(73.8)
28¼ (71.8)
24½ (62.2)
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL
F
G (min.)
H
I
Min.
Max.
Min.
Max.
27" (68.6cm)
24
7
/
8
(63.2)
25¼ (64.1)
23½ (59.7)
27¼ (69.2)
28½ (72.4)
27
1
/
8
(68.9) Min.
30" (76.2cm)
28½ (72.4)
29 (73.7)
23½ (59.7)
27¼ (69.2)
28½ (72.4)
30
1
/
8
(76.5) Min.