Kuppersbusch IKE2460-1 User Manual

Other manuals for IKE2460-1: User Manual
Manual is about: Refrigerator

Summary of IKE2460-1

  • Page 1

    User manual refrigerator ike2460-1.

  • Page 2: Safety

    Contents safety instructions 2 operation 4 first use 4 daily use 4 helpful hints and tips 5 care and cleaning 5 what to do if… 6 technical data 8 installation 8 environmental concerns 14 subject to change without notice. Safety instructions in the interest of your safety and to ensure the correct us...

  • Page 3: Daily Use

    – avoid open flames and sources of igni- tion – thoroughly ventilate the room in which the appliance is situated • it is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short- circuit, fire and/or electric shock. Warning! Any electrical com...

  • Page 4: Environment Protection

    Environment protection this appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insula- tion materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli- anc...

  • Page 5: Positioning The Door Shelves

    Positioning the door shelves to permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposi- tion as required. Helpful...

  • Page 6: Periodic Cleaning

    Charging must therefore only be carried out by authorized technicians. Periodic cleaning the equipment has to be cleaned regularly: • clean the inside and accessories with lukewarm water and some neutral soap. • regularly check the door seals and wipe clean to ensure they are clean and free from deb...

  • Page 7

    Problem possible cause solution the appliance does not operate. The lamp does not operate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is...

  • Page 8: Replacing The Lamp

    Replacing the lamp 1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cov- er. 3. Remove the lamp cover (refer to the il- lustration). 4. Replace the used lamp with a new lamp of the same power and specifical- ly designed for household appliances. (the maximum powe...

  • Page 9: Electrical Connection

    Electrical connection before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power sup- ply socket is not ear...

  • Page 10: Door Reversibility

    Door reversibility the door of the appliance opens to the right. If you want to open the door to the left, follow these steps before you install the appliance: 1. Loosen and remove the upper pin. 2. Remove the door. 3. Remove the spacer. 4. With a key, loosen the lower pin. On the opposite side: 1. ...

  • Page 11

    1 2 install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the op- posite side of the hinge. 44mm 4mm adjust the appliance in ...

  • Page 12

    Remove the correct part from the hinge cover (e). Make sure to remove the part dx, in the case of right hinge, sx in oppo- site case. E e d c attach the covers (c, d) to the lugs and the hinge holes. Attach the hinge covers (e) to the hinge. Disconnect the parts (ha), (hb), (hc) and (hd). 12.

  • Page 13

    Ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm install the part (ha) on the inner side of the kitchen furniture door. Ha hc push the part (hc) on the part (ha). Ha hb 8 mm open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (hb) into guide (ha). Put together t...

  • Page 14

    Ha k 8 mm remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (k). Hb place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the ap- pliance door by adjusting the part (hb). Hb hd p...

  • Page 15

    15.

  • Page 16

    212720473-00-3132013.