Kuryakyn RoadThunder Speaker Pods Installation Instructions - page 2
PAGE 2
302711
DPF-MRK-003 REV A 4/22/16
ROADTHUNDER SPEAKER PODS BY MTX, SATIN BLACK
2711
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYA KYN.C OM
INSTALLATION INSTRUCTIONS
-CONTINUED-
INTRODUCTION
Thank you for purchasing this Kuryakyn RoadThunder Speaker Pods by MTX that are designed to work with most Bluetooth enabled devices including
iPhone® and Android® smartphones and tablets. This easy to install and use, all in one unit is capable of transforming your Bluetooth enabled mobile
device into the center of your vehicle’s audio system. Designed to mount on any motorcycle handle bars with a 7/8” or 1” diameter. Congratulations
and enjoy the ultimate audio experience!
FEATURES
3” SPEAKER PODS SPECS:
•
High-impact ABS enclosures in chrome or satin black finish
•
Low current draw: 5 amps
•
Overall height when mounted is 4.8”
•
Includes 3.5 mm input and output connectors
•
1-1/4” handlebar clamp mount available separately, P/N 1468 Chrome, 2792 Satin Black
•
100W Peak Music Power
INSTALLATION
The RoadThunder Speaker Pods can be used with any 12-volt battery and can be mounted to
a variety of bars using the included hardware. Mount the speakers where they have sufficient
clearance, position the speakers so the speakers are directly at the rider.
MOUNT BRACKETS TO HANDLEBAR FIRST, THEN INSTALL SPEAKER PODS
STEP 1
Determine the diameter of the handlebar and use either the 7/8” Adaptor with 1” Bracket or just
the 1” Bracket
Note: If you have a 1-1/4” diameter handlebar you can purchase that part separately on our
website.
STEP 2
Install brackets on handlebars where Sound Bars do not obstruct the riders view. Use hardware
that is included with the brackets.
STEP 3
Once brackets are installed, add the Speaker Pods with the hardware provided:
A) Add the 3” Amp Speaker POD to the left side of rider’s perspective & 3” Speaker POD to the
right side of rider
Use one of the M8 1-1/4” x 45 Cap Screw provided on each bracket along with two M8 internal
Tooth Lock Washers add to top and bottom surface of bracket, do the same on other bracket.
STEP 4
Adjust the speaker pods so the speakers are directed at the rider’s head. To adjust and align
the logo on the Speaker Pods mesh screen there is a very small pin size hole located at the
bottom of the front ring. Use a small pin or paper clip, press in, and turn the ring. Rotate trim
counterclockwise to removed trim ring. Once the ring has been removed, adjust the mesh
screen accordingly, then reinstall. Make sure all screws are securely fastened and tightened.
STEP 5
Connect Speaker Pods to the Wire Harness.
TWO PRONG
CONNECTING OF THE SPEAKER PODS
THREE PRONG
CONNECTING OF THE HARNESS