Kuryakyn RoadThunder Speaker Pods Installation Instructions - page 3

PAGE 3

302711 

DPF-MRK-003 REV A 4/22/16

ROADTHUNDER SPEAKER PODS BY MTX, SATIN BLACK 

2711

866 277 9598  |  INFO@KURYAKYN.COM

454 COUNTY ROAD VV SOMERSET, WI 54025

KURYA KYN.C OM

INSTALLATION INSTRUCTIONS

Route all harness wires through the bike’s frame to the battery and proceed to the next steps in 

power connection.

POWER CONNECTION

SPEAKER PODS WIRE HARNESS CONNECTION

STEP 1

Connect the Red wire (with the in-line fuse) power wire from the wire harness to the positive 

terminal on the battery.  The Black wire is a ground wire and needs to be attached to the 

negative terminal on the battery.

Note: Route and secure the wiring away from any moving parts, pinch points or extreme heat. 

Keep the included fuse off the fuse holder until all wiring connection have been made and 

secured.

STEP 2

Use the included T-Tap Quick Connect Female connector and install directly onto the ACC/Key 

ignition wire on the motorcycle using a pair of pliers. Then once the T-Tap female connector is 

installed connect the Orange wire with red male connector onto this T-Tap female connector.

Note: Route and secure the wiring away from any moving parts, pinch points or extreme heat.

Note: Place the included fuse in the fuse holder when all wires are connected and secured.

AUDIO CONNECTION

DIRECT CONNECTION FROM AUDIO SOURCE

STEP 1

Use the included 3.5mm male connector on the Speaker Pods and connect directly to an audio 

source.

Note: Please note with this type of connection, the audio source will control the volume of the 

pods.

-CONTINUED-

3” AMP 

SPEAKER POD

3” SPEAKER 

POD

WIRE HARNESS