L. G. B. Mogul Instruction Manual - Standing Sounds:
locomotive is started.
The bell and whistle also can be
triggered using the LGB Sound
Trigger Magnet (17050) included
with this model. The 17050 snaps
between the ties of most LGB
track sections.
The magnet in the 17050 is under
the LGB logo. If the contact is
installed with the logo on one side
of the track, it will trigger the whis-
tle as the model passes. If the
contact is reversed, it will trigger
the bell.
Standing sounds:
With the
Multi-Train System, you hear the
air pump and the boiler sounds
while the loco is standing.
To hear the standing sounds with
analog operation, a low voltage
(approx. 6.5 volts) must be main-
tained on the tracks. Turn the
throttle to a low setting so that the
loco does not yet start, but you
can hear the sounds.
Hint: To obtain standing sounds
with analog operation while the
throttle is turned off, the 65011
Sound Unit Power Storage must
be installed.
Hint: This model is equipped with
a starting delay circuit. This
enables the model to produce
standing sounds while it is
stopped.
Attention! Do not connect this
model to other locomotives with
different starting characteristics.
This can damage the internal
gearing.
Lighting
This model features directional
lighting. The model has a "flat"
multi-purpose socket, with a
removable cover, on the rear of
the tender (Fig. 4). This socket
can be used to provide track
power to cars with lighting or
sound electronics.
To remove the cover of the sock-
et, pull it straight out. If the cover
is tight, gently use a small straight
screwdriver to pry it out. (Do not
pull out the rectangular outer
housing.)
Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gener-
ator is overfilled, it will not convert
the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the heat-
ing element in the center of the
smoke generator. It is hot and
fragile.
Hint: The smoke generator can
be run “dry” without smoke fluid.
Power Supply
Attention! For safety and reliabil-
ity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of at
least 1 amp. For more informa-
tion on LGB power supplies for
indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Service).
Hint: Additional expert instruc-
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings and the side
12